The Hiro uses the MNK65_STM32 PCB. We’re waiting for our pull request for VIA to go through so that you can use it with the web and newer versions of VIA. In the meantime, here is a solution to get VIA up and running with the Hiro.

VIA JSON Loading Guide:

For VIA Desktop V1.3.1 (VIA Desktop V1.3.1 Download Link)

1. Download the following JSON file. (”right click” + “save as” to save the file)
2. Load the provided JSON file via the “Design” tab on the top. (If you don’t see the Design tab go to Settings and enable “Show Design tab”)
3. Navigate to the Design tab, click “Load” and select the provided JSON file.
4. The Configure page should work at this point and you can proceed to make changes using VIA.

For VIA Desktop V2.0 and VIA Web

1. Download the following JSON file. (”right click” + “save as” to save the file)
2. Load the provided JSON file via the “Design” tab on the top. (If you don’t see the Design tab go to Settings and enable “Show Design tab”)
3. Navigate to the Design tab, click “Load” and select the provided JSON file.
4. Disable “Use V3 definitions (via/next)". This step is required for the JSON definitions to work correctly.
5. The Configure page should work at this point and you can proceed to make changes using VIA.

Please note that by downloading these files you are agreeing with the following terms and conditions:

1. MONOKEI does not provide support for any of these files provided, you agree to take full responsibility of its usage. These files are provided "as is" without warranty of any kind, express or implied, including but not limited to the warranties of merchantability, fitness for a particular purpose and non-infringement. In no event shall the authors or copyright holders be liable for any claim, damages or other liability. Whether in an action of contract, tort or otherwise, arising from, out of or in connection with the files or the use or other dealings in the software.